Beurer GL Instrucciones de operaciones descargar pdf (Pagina 19)

Beurer GL32 mg/dL

The lancing device can now be used to take the blood

sample. Ensure that the blood remains in a droplet

form and is not smeared.

Blood sample from the fingertip

Place the lancing device firmly against the finger,

slightly to the side of the centre of the fingertip. Press

the release button. Lift the lancing

device from the finger. A round blood

droplet of at least 0.5 microlitres

(approx. 1.2 mm, original size: z) is

required.

Blood sample from an alternative site (AST)

Choose a site that is soft, not next to a bone, with no

visible veins and without excessive body hair. Warm

the puncture site to ensure good circulation, for exam-

ple by lightly massaging the area. Place and hold the

lancing device against the puncture site for a few

seconds and press the release button. Continue to

hold the lancing device against your skin until a round

droplet of blood has formed under the cap. Maintain

the pressure until the blood droplet has reached a size

of at least 0.5 microlitres (approx. 1.2 mm, original

size: z). Lift the lancing device carefully away from

the skin.

If insufficient blood was collected, increase the punc-

ture depth and repeat steps 5 to 7.

Untwist the cap and carefully remove it from the lanc-

ing device.

Place the protective disk you kept earlier flat on a hard

surface. Pierce the protective disk with the tip of the

needle so that the needle is covered.

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 35 36

Sin comentarios

Beurer GL Instrucciones de operaciones Pagina 19